|
VDSL-CX VDSL with Conexant chipset
The capabilities of the VDSL features include the following:
- Variety of VDSL testing modes for service verification, local loop
testing, and network connectivity.
| Mode |
Function |
| VDSL Modem emulate mode |
Used to test basic VDSL physical layer rates,
quality and line statistics.
Also used for testing the following types
of lines: IP over Ethernet and PPP over Ethernet |
| VDSL Through mode |
Used for testing the following types of lines:
Bridged Ethernet and PPP over Ethernet. |
| Ethernet TE mode |
Used for testing IP over Ethernet and PPP over
Ethernet. |
- Wide range of compatibility with industry standards
- On-board web browser for validating the customer’s internet connection
- Trace route and FTP/HTTP throughput capability
- Customer premise equipment emulation to turn up and troubleshoot VDSL
service, including Ethernet terminal equipment (TE)
Wide Band 2 (WB2)
Complete copper testing to support VDSL/VDSL2 and triple-play deployments
- Expanded copper testing frequency range
- Tx/Rx Tones ranging from 100 kHz to 30 MHz
- Wideband Noise measurements from +15 to -90 dBm
- Impulse Noise measurements from +15 to -60 dBm
- Spectral analysis with spectral masks and band plans up to 30 MHz (-28 to
-150 dBm/Hz)
Wideband copper SIM functionality available in combination with
VDSL/VDSL2 test SIMs
Fully compatible with the HST-3000-CE and HST-3000C-CE mainframes, the
HST-3000WBII SIMincludes an internal coppermeasurement board that enhances the
functionality of the HST-3000C mainframe copper measurement board and adds
limited wideband copper test capability to non-copper test mainframes. The WBII
SIM features dual Tip & Ring (T&R) and Ground interfaces. Due to
high-frequency range and measurement sensitivity, this SIM supports special test
cables, which can also be used with existing HST-3000C copper test functions.
For the most accurate results, use of specially insulated cables for testing
higher frequency services such as VDSL2 is recommended.
|
