Schonstedt u-LOCATE+ Underground Pipe & Cable Locator w/ Transmitter
Condition: Refurbished/Calibrated
Warranty: 1 Year Warranty
Shipping: USA & Worldwide
- Schonstedt u-LOCATE+ Underground Pipe & Cable Locator (BC# 55221- L/T*)
- Schonstedt u-LOCATE+ Transmitter (BC# 55222- L/T*)
- Direct Connect Leads
- Ground Stake
- Carrying Case (G)
Schonstedt u-LOCATE+ Underground Pipe & Cable Locator w/ Transmitter
The Schonstedt u-LOCATE+ is a portable system used to find and trace buried pipes and cables. It includes a handheld receiver and a separate transmitter that work together to help locate underground utilities before digging or maintenance work.
The transmitter puts a detectable electrical signal onto a suitable pipe or cable. Depending on the setup, it applies the signal through direct connection leads, a compatible signal clamp, or induction from above ground. The receiver then detects that signal.
As the operator walks over the area, the receiver uses sound, signal-strength readings, and direction arrows to help trace the utility’s route. It also estimates depth under suitable conditions. These features help workers mark where a buried line runs.
The u-LOCATE+ supports 33 kHz and 82 kHz active locating frequencies and a passive mode for detecting signals from some energized power lines. It can also locate a compatible 512 Hz sonde—a small signal-emitting device placed inside a pipe—helping trace nonmetallic pipes.
The system is designed for utility crews, contractors, and maintenance workers. Its battery-powered design supports field use, while the transmitter includes a signal-boost function. Its main purpose is to improve awareness of buried utilities; successful detection depends on the line, signal connection, and surrounding conditions.
Features:
- Dual-frequency locating: Uses 33 kHz and 82 kHz signals to trace buried utilities.
- 1-watt transmitter: Applies a detectable signal to suitable pipes and cables.
- Signal boost: Increases transmitter output when needed.
- Passive power mode: Detects 50/60 Hz signals from some energized electrical lines.
- 512 Hz sonde detection: Locates compatible sondes placed inside pipes, including nonmetallic pipes.
- Depth estimation: Estimates utility depth under suitable conditions.
- Left/right guidance arrows: Help the operator follow the buried line.
- Signal-strength display and audio: Help identify and trace the target.
- High-contrast screen: Improves visibility in bright sunlight.
- Headphone socket: Makes audio signals easier to hear in noisy areas.
- Direct connection: Uses leads to apply the transmitter signal to an accessible utility.
- Inductive locating: Applies an 82 kHz signal without a direct connection.
- Optional signal clamps: Allow signal application around suitable cables or pipes.
- Battery-powered operation: Uses six AA batteries in the receiver and four D batteries in the transmitter.
- Rugged housing: Designed for outdoor fieldwork.
- Reflective markings: Improve equipment visibility.
- Transmitter storage compartment: Holds connection accessories.
- Standard kit accessories: Includes connection leads, ground stake, magnet, batteries, and a soft carrying case.
| Feature | Specification |
|---|---|
| Equipment type | Underground pipe and cable locator |
| Active frequencies | 33 kHz and 82 kHz |
| Passive power mode | 50/60 Hz |
| Sonde frequency | 512 Hz |
| Maximum active locating depth | 5.8 m / 19 ft |
| Maximum sonde depth | Up to 4.5 m / 15 ft; sonde dependent |
| Stated positional accuracy | 5% |
| Guidance | Left/right arrows and audio |
| Sensitivity control | Automatic or manual gain |
| Display | High-contrast LCD |
| Headphone connection | Included |
| Batteries | Six AA |
| Typical runtime | 20 hours |
| Protection rating | IP65; NEMA 3S |
| Housing | High-impact ABS plastic |
| Operating temperature | −10°C to 50°C |
| Weight with batteries | Approximately 1.1 kg / 2.4 lb |
| Dimensions | 65.1 × 9.9 × 22.1 cm |