Westover HD1 Handheld Fiber Inspection Display ZP-FBP-9000 EXFO
Condition: Refurbished
Warranty: 1 YEAR WARRANTY
Shipping: USA & Worldwide
- Westover HD1 Hand-Held Display Unit (BC# 41987)
- AC Adapter/Charger
- User Manual On CD-ROM
- Carrying Case (G)
HD1 Hand-Held Display
Bright, hight contrast 2.5" TFT active matric LCD Display. The probe's hight magnification projects a 530-micron field onto the LCD display. The Auto-Shutoff Interval switch can be set to one of three settings: 10 sec., 30 sec., or Infinity. Pressing the On/Off switch will turn the LCD display On for the set interval time. Pushing the switch again, turns Off the display.
Battery Power and Recharge
The display utilizes a NiMH rechargable battery pack. From a full charge, the system can operate continuously for approximately 3 hours. You can ectend the battery life by using one of the two display's Auto-Shutoff Interval settings. The system's "Low Battery" indicator signals when the battery runs low. (Approximately 15 minutes before automatic shutdown. After this time, the battery must be recharged.) Use external power (AC power adapter) to charge the battery pack. Typical battery charging time is approximately 2-3 hours.
AC Power
Using the AC power adapter has the following advantages:
- Saves internal battery power for portable operation later.
- Charges internal battery pack.
- Allows extended operation.
The two LED's on the front of the Hand-Held display, indicates the display's AC Power and Battery Power status.
| Specifications | |
| Parameter | Specification |
| Dimensions | 9.7 x 21.8 x 4.8 cm (3.8 x 8.6 x 1.9 in) |
| Weight | 400 g (14.1 oz) |
| Video Display | NTSC with dedicated connector for probe or conversion cable |
| Connector | 4-pin Hirose™ input for FBP probes |
| Power source | Li-ion battery (Sony® type NP-F550/F570) or AC adapter/charger (100 – 240 V AC) |
| Run time | ~2 hours (continuous on) |
For full Westover HD-1 product specifications, please click here: Westover HD-1