Alber 1101-006 1102-006 Spike Probe Set For CRT Cellcorder Resistance Testers

Alber Cellcorder CRT Spike Probe


The Cellcorder Spike Probes are for use with hard-to-access battery terminal posts. Using these probes, it is possible to measure the internal resistance of a cell or module and take float voltage readings. The coaxial design of the probe tips ensures the current and voltage pins make solid contact with the battery posts. Depending on the Cellcorder model, the probes can also be used for combined or computed resistance readings. The probes are designed for 6 volt and 12 volt UPS cabinet applications where access is both difficult and safety is a concern. However, the probes may also be used on any cell or module up to 12V. When used with the Cellcorder, the LEDs on the probes light the work area and indicate test status. While the LED-lighted probes are compatible with most Cellcorders, some early models require a factory-installed retrofit.

1101-006: 9.25" Straight Probe w/ Light

1102-006 10" Straight Probe w/ Light

Alber 1101-006 9.25" & 1102-006 10" Straight Spike Probe Set

Please Note that 1101-006 Probe is missing a piece of the shell near it's probe tip, This Probe Is FULLY Functional

For Use With Alber CRT Series Cellcorders
(Cellcorders NOT INCLUDED!)

1101 006 1102 006

Alber 1101-006 1102-006 1101-006 1102006 Spike Probe Set Models On Sale Warranty Calibration Backed by The Best Service and Lowest Prices in the Industry.

 

BC# 20781M-L/T* 20782M-L/T*

• Alber 1101-006 9.25" Straight Spike Probe w/ Light (BC# 20781M-L/T*)
• Alber 1102-006 10" Straight Probe w/ Light (BC# 20782M-L/T*)